General Information; Contact Address; Warranty; Information On The Internet - Burkert Positioner TopControl Basic Quick Start Manual

▶ When unscrewing and screwing in the body casing or the
transparent cap, do not hold the actuator of the process valve
but the basic housing of Type 8696.
▶ Do not feed corrosive or flammable media into the device
connections.
▶ Do not feed any fluids into the connections of the device.
▶ After the process is interrupted, restart in a controlled man-
ner. Observe sequence:
1. Connect electrical or pneumatic power supply.
2. Charge the device with medium.
▶ Observe intended use.
ATTENTION!
Electrostatic sensitive components or modules.
The device contains electronic components which react sen-
sitively to electrostatic discharge (ESD). Contact with electro-
statically charged persons or objects is hazardous to these
components. In the worst case scenario, they will be destroyed
immediately or will fail after start-up.
▶ Observe the requirements in accordance with EN 61340-5-1 to
minimize or avoid the possibility of damage caused by sudden
electrostatic discharge.
▶ Also ensure that you do not touch electronic components when
the power supply voltage is present.
6
english
Type 8696 REV.2

General information

4 GENERAL INFORMATION
4.1

Contact address

Germany
Bürkert Fluid Control System
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: info@burkert.com
International
Contact addresses can be found on the final pages of the printed
operating instructions.
And also on the Internet at:
www.burkert.com
4.2

Warranty

The warranty is only valid if the positioner Type 8696 is used as
intended in accordance with the specified application conditions.
4.3

Information on the internet

The operating instructions and data sheets for Type 8696 can be
found on the Internet at:
www.burkert.com