Safety Code - Precor 700 Series Assembly Manual

Test safety features
IMPORTANT
Before any exerciser uses the treadmill, verify that the STOP button, reset switch,
and Auto Stop™ feature are all working correctly.
To test the Stop button:
1. Start any workout on the treadmill.
2. Press STOP once. The console indicates that the workout is paused.
3. Press STOP again. The console displays a workout summary.
To test the reset switch:
1. Start any workout on the treadmill.
2. Give the safety clip lanyard a slight tug. The reset switch pops up and the
treadmill should slow to a stop immediately.
3. Press the reset switch back into its normal position. The console should reset
itself and return to the Welcome screen or banner.
Treadmill Auto Stop
IMPORTANT
The default setting for this feature is ON. An administrator can turn off this
feature in the System Settings; however, Precor recommends it remain ON.
Auto Stop™ (Automatic Stop) is a feature designed to bring the treadmill to a
gradual stop after two minutes, when it is not in use. This might occur if an
exerciser steps off the treadmill before the end of a workout and leaves the
treadmill running.
To test Auto Stop™:
1. Start any workout on the treadmill, but DO NOT step onto the running belt.
2. Wait two minutes without stepping onto the running belt. At this point or
shortly beforehand, the treadmill should slow to a stop and the console should
ask the previous user to confirm that he or she is still present.
If there is no confirmation, the console returns to the Welcome screen or
banner and it is safe to step onto the running belt.

Safety code

Activate a safety code to prevent unauthorized use of the treadmill. This setting
requires the exerciser to enter a code (1 2 3 4) on the keypad before the treadmill
will operate.
To activate a safety code for your setting:
1. Enter code 5651565 to go to Club Settings.
2. Press the up/down arrows to scroll to the Safety Code setting.
3. Press OK for Safety Code setting.
4. Use the up/down arrows to enable the setting.
5. Press OK to save the setting.
6. Test the Safety Code.
NOTE
If the safety code is properly enabled, you will be prompted to enter a safety
code (1 2 3 4) on the keypad before you can begin a workout.
15