Begin Assembly - Precor 700 Series Assembly Manual

Begin Assembly

WARNING
DO NOT attempt to connect electrical power until all assembly
procedures are complete and the console is properly installed.
To attach the uprights to the treadmill:
1. Remove the hood from the treadmill base and set it aside.
2. Position a base side cover against the treadmill frame so that the tabs fit into
the frame.
Figure 1
3. Attach the base side cover using two screws
and one for the front attachment.
Figure 2
: one for the side attachment
4. Position the right side upright support near the base frame and route the data
cable inside of the base side cover and up through the right upright.
IMPORTANT
DO NOT pinch or crush the cable during assembly.
Figure 3
5. Position the right upright support onto the base frame so that the side cover
lip fits inside the upright support and attach it using three screws
three washers . Partially tighten the fasteners.
Figure 4
6. Repeat Steps 2 through 5 to attach the left upright support.
NOTE
Route PVS and network cables through the inside of the left upright
support. Be careful not to pinch the cables.
and
6