Precor 700 Series Assembly Manual page 8

To attach the filter to the drive power cable:
1. Disconnect the existing power cable from the drive unit, power filter, and
ground terminal. Then completely remove it from the treadmill.
Figure 12
2. Connect the new power cable according to Figure 13 and Table 1.
Figure 13
Table 1
Position Connector
Drive input connectors
Brown lead with quick-connect terminal
Blue lead with quick-connect terminal
Green and yellow lead with quick-connect terminal
AC input cable to the power cable
3. Use the Velcro fasteners to attach the power supply on the right side of the
treadmill base. Plug the AC input cable into the socket on the power supply.
4. Route the DC output cable through the cable ties behind the power supply,
toward the upright support on your right. Bend the cable ties over the DC
output cable to hold it in place.
NOTE
Bundle the excess cable and secure it under the cable clips.
5. Connect the black AC power cable on the AC wiring harness to the socket on
the power supply.
9