Precor 700 Series Assembly Manual page 7

To attach the heart rate bar:
1. Position the heart rate bar assembly against the dash frame and attach it
using two screws and two washers
Figure 8
2. Route the heart rate cable up through the back frame and out through the top
hole (Figure 8).
3. Remove the screw from the bottom of the tread arm.
Figure 9
4. Remove the bottom and front plastic covers from each tread arm.
. Partially tighten the fasteners.
5. Fit the tread arm into the heart rate bar and against the dash assembly. Attach
it using two screws and two washers
the screws.
Figure 10
6. Attach the underside of each heart rate arm using one screw
the fasteners.
Figure 11
7. Repeat Steps 3 through 6 to attach the other arm and then tighten all six
socket head screws to 25 ft-lb (33.90 Nm) of torque.
NOTE
To install a touchscreen console, continue with the next section.
To install a non-touchscreen console, continue with the section Attach the
treadmill.
. Use a hex key to partially tighten
. Fully tighten
8