Precor 700 Series Assembly Manual page 10

Attach the treadmill hood
Place the hood onto the treadmill. Using a #3 Phillips head screwdriver, attach it
using four screws . Fully tighten the fasteners.
Figure 18
To attach the safety key assembly:
1. Fit the bottom part of the safety key assembly onto the bottom of the dash
assembly and heart rate arms.
NOTE
Flex the plastic to snap it into place.
2. Position the top piece of the safety key assembly on top of the bottom part.
Figure 19
3. Route the cable under the black bar on the safety key assembly and up
through the dash (Figure 19).
4. Attach the top part of the safety key assembly using two screws
Figure 20
.
11