Precor 700 Series Assembly Manual page 9

Install the accessory jack
IMPORTANT
The touchscreen console includes an accessory jack panel that you must install on
the treadmill. The panel connects the TV and Ethernet cables to the facility's
network.
For touchscreen consoles only:
1. Remove the screws securing the blank plate at the right-front corner of the
treadmill. Discard the blank plate.
Figure 15
2. Thread the cable assembly down through the channel in the upright support
on your right. Drape excess cable over the inside edge of the support and tape
into place, if necessary.
Figure 16
3. Pass the lower end of the TV cable through the right-hand grommet, and
insert it into the connector inside the panel. Use a 7/16-inch torque wrench to
tighten the connectors to 30 in-lb (3.39 Nm) of torque.
4. Pass the lower end of the Ethernet cable through the right-hand grommet and
snap it into the eight-pin coupler in the panel.
5. Fit the lower ends of any optional console cables into the notch in the upper
edge of the panel.
6. Replace the panel and fully tighten the corresponding screws.
WARNING
Before you finish assembling the treadmill base, examine the
electrical bleed line between the belt motor and the frame. Make
sure the bleed line is connected securely to both the motor and the
frame as shown in the following figure, and verify that it is not
damaged.
DO NOT connect the treadmill to electrical power while the hood is
removed.
Figure 17
10