Table of Contents
Advertisement
The Mode/Reset switch can be used to:
•
Initiate a Hardware Reset
•
Enter Console Mode
•
Reload Factory Defaults
Note: Refer to Section 3: Modbus Gateway Setup and Connections for more information on using the Mode switch.
ETHERNET CONNECTOR
Modbus Gateway models using 10BaseT/100BaseTX network connections use an RJ45 receptacle. The
Modbus Gateway is connected to a standard Ethernet network drop using a straight-through RJ45 (male)
Ethernet cable.
Note: Refer to Appendix D for connection pin-outs.
SERIAL PORT CONNECTOR
Model BB-MESP211T has a 5-position terminal block connector.
Modbus Gateway – BB-MESP211T
Ethernet Connector.
Five-Position, Pluggable Terminal Block
9
Advertisement
Table of Contents
