Cleaning The Chain Guide; Greasing The Anti-Kickback Chain Guide - pellenc SELION M12 Operating Instructions Manual

1. Set the battery switch to "0" and disconnect the con-
nector.
2. Remove the chain guide (7) and the chain (6) (see.
Section 6.3, "REPLACING THE CHAIN AND THE
CHAIN GUIDE".)
3. Remove the circlips and the sprocket
4. Replace the sprocket
5. Reinstall the assembly and pay attention to the di-
rection of installation of the circlip.
Caution
The
after each dismantling operation
(ref.:01357).

6.9. CLEANING THE CHAIN GUIDE

1. Set the battery switch to "0" and disconnect the con-
nector.
2. Remove the chain guide (7) and the chain (6). (see
Section 6.3, "REPLACING THE CHAIN AND THE
CHAIN GUIDE".)
3. Clean the groove, grease holes and the oblong hole
of the chain guide
4. Reassemble the chain guide and the chain.
Important
Disassemble the chain guide and clean at the
groove of the chain and grease holes (see dia-
grams opposite). Repeat the operation daily.
Carry out this operation each time you change work
sites in order to disinfect the tool a little.
Clean the lubricating holes as often as necessary.

6.10. GREASING THE ANTI-KICKBACK CHAIN GUIDE

Lubricate the chain wheel nose sprocket (7) every day
using a grease gun (ref.: 68518) through the grease hole
(see diagram opposite).
Note
Consumables sold separately.
CHAINSAW SELION M12
circlips must be replaced
51_149238-A
33