Electronic - pellenc SELION M12 Operating Instructions Manual

Caution
Always start the motor before bringing the chainsaw into contact with the wood.
1. Remove the chain guide protector.
2. Set the Pellenc tool battery On/Off switch to the On position "I". From the moment the indicator light (12) comes
on, the tool is energized and ready to operate.
3. Keep the safety trigger (3) pressed while holding the chainsaw by the rear handle with your right hand and the
front handle with your left hand.
4. In order to guarantee chainsaw safety when relocating, an electronic device blocks the motor control 3 seconds
after the motor is stopped. Press the trigger (2) twice consecutively to restart the motor. The chainsaw chain
continues to turn as long as the trigger (2) is maintained pressed.
5. Release the trigger (2) to stop the motor.
Warning
When either the guide or the chain is replaced, they must be run in by operating the tool with-
out sawing for 1 to 2 minutes. Check the chain tension after the running-in phase, see page Sec-
tion 6.4, "Automatic chain tensioning".
Tip
Allow the chainsaw to cut without pressing excessively.

5.4. ELECTRONIC

Your chainsaw is fitted with an impact detection system
In the event of impact (kickback) your chainsaw will stop
immediately.
Warning
Make sure the chain is not in contact
with wood before restarting the chain-
saw.
CHAINSAW SELION M12
51_149238-A
21