Maintenance Frequency; Replacing The Chain And The Chain Guide - pellenc SELION M12 Operating Instructions Manual

• Rule No. 4: The depth limiters must be correctly
adjusted.
The depth limiters must be correctly adjusted and of
the right shape to ensure good performance and safe-
ty.
Refer to procedure Section 6.7, "Adjusting the depth
limiters"

6.2. MAINTENANCE FREQUENCY

Visual inspection of the tool
Functional check of the safety trigger
Check and topping up of the oil
Checking the greasing of the chain
Check and tensioning of the chain
Checking that the chain is sharp
Checking the chain brake
Cleaning and cleaning the chain guide
Greasing the chain guide
Checking the sprocket for wear
Check the capacity of the battery
Have the tool inspected by an approved dis-
tributor
Warning
Overhaul the chainsaw every 200 hours or at least once a year. Always make sure the tool
is clean and its battery is charged before storing it.

6.3. REPLACING THE CHAIN AND THE CHAIN GUIDE

Important
Do not use any chain guides or chains other than those recommended.
Note
The chain guide must be replaced whenever necessary or when 3 or 4 chains have been replaced.
24
CHAINSAW SELION M12
51_149238-A
At each Every
start-up hour
X
X
X X
X
X
X
X
X
Every 2 Every After use Every
hours week
X
X
X
X
X
year or
when nec-
essary
X