Running-In (Before First Use); Chain Protection - pellenc SELION M12 Operating Instructions Manual

Warning
Carry out a forced lubrication cycle at the start of each season in order to check the chain
lubricating function. Carry out forced lubrication whenever necessary.

4.4. RUNNING-IN (BEFORE FIRST USE)

Warning
Before the first use, it is imperative to run-in the chain guide and chain.
To run-in the chain guide and the chain:
1. Run the chainsaw for 1 or 2 minutes without contact
2. After this running-in phase, check the tension of the chain, and tighten it if necessary.
Note
Once all commissioning procedures have been completed, the tool is ready for use

4.5. CHAIN PROTECTION

Put on the chain protector whenever transporting, han-
dling and storing the tool.
Note
Never transport the chainsaw without its protective
cover. The chainsaw must always have its protec-
tive cover on when moved.
The chain protector can be used as a holster that hangs
from the belt.
CHAINSAW SELION M12
51_149238-A
19