Usage; Usage Situation; Holding The Tool; Start-Up - pellenc SELION M12 Operating Instructions Manual

5. USAGE

5.1. USAGE SITUATION

Do not use the chainsaw to prune trees one-handed when in an unstable work position. It is preferable to use a
hand saw when cutting small diameter wood at the ends of branches.
Tree service chainsaws should only be used one-handed where:
• operators cannot gain a work position enabling two-handed use, and
• they need to support their working position with one hand, and
• the when saw is being used at full stretch, at right angles to and out of line with and away from the operator's body.
Warning
Never cut with the kickback zone at the tip of the chainsaw guide bar,
Never hold the section being cut.
Never attempt to catch falling sections.

5.2. HOLDING THE TOOL

1. Take the chainsaw by the handles and ensure noth-
ing is touching the chain.
2. Attach the power supply cord to your arm using the
supplied armband.
3. The chainsaw is in its "start-up" position.
Warning
Never disconnect the power cord
from the battery without checking that
the On / Off switch is in the off position
«0».
Caution
Do not cut anything other than wood.
Always keep your left hand on the front handle.

5.3. START-UP

Note
The indicator on the rear handle indicates that the tool is switched on
20
CHAINSAW SELION M12
51_149238-A