Commissioning; Assembly Of The Chain And Chain Guide (1St Use) - pellenc SELION M12 Operating Instructions Manual

4. COMMISSIONING

4.1. ASSEMBLY OF THE CHAIN AND CHAIN GUIDE (1ST USE)

Note
Refer to the numbering of the parts in the illustration Section 3.1, "Description".
Caution
Before working on the tool, check that
the On / Off switch is in the off position
«0» and disconnect the battery power
lead.
1. Remove the chain protector (5) and remove the
foam plug that blocks the oil outlet before fitting the
bar and chain.
The chain guide and the chain are delivered unassem-
bled. Assemble the chain guide and the chain.
2. Position the chain guide (7) in its place.
3. Push the guide (7) towards the sprocket to engage
the lock.
4. Fit the chain (6) while respecting the cutting direc-
tion.
5. Refit the chain protector (5).
6. Retighten the lock nut (8) using the captive telescop-
ic tightening wrench (11). During this operation, the
automatic chain tensioning mechanism should be
triggered.
Note
For more details on the procedure, consult: Section 6.3, "REPLACING THE CHAIN AND THE CHAIN GUIDE".
14
CHAINSAW SELION M12
51_149238-A