Table of Contents
Advertisement
STARTING AND USE
Adjust the tension as often as necessary.
Check the tension by pulling the chain in the middle of the
guide: 1 to 3 drive links should appear.
CHECKING AND REPLACING THE SPROCKET
Remove the chain guide and the chain.
Remove the circlip and remove the sprocket.
Replace the sprocket whenever necessary or when two
chains have been replaced (P/No. 85643).
Reinstall the assembly and pay attention to the direction of
installation of the circlip.
The circlip must be replaced each time it is removed
(P/No. 01357).
Always set the switch to the off position «0» and
disconnect the battery connector before doing work.
CLEANING THE CHAIN GUIDE
Remove and clean the chain guide every day. Clean the
guide and the lubricating holes.
Carry out this operation each time you change work
sites in order to disinfect the tool a little.
Clean the lubricating holes as often as necessary.
Always set the switch to the off position «0» and disconnect
the battery connector before doing work.
LUBRICATING THE CHAIN GUIDE
Lubricate the chain guide every day using a grease gun (P/
No. 68518).
51_08_030A
17
51_08_025A
51_07_015A
51_07_016A
Advertisement
Table of Contents
