Dmx-512 Control Connection - SGM PALCO 3+ User Manual

Fix the clamp to the bracket by tightening the M12 screw up on it to the Ф13 hole which is in
the middle of the bracket. Pass the safety rope through the connecting hole located under the
side panel, hanging on the fixed bracket or the other fixed station, it can also be floor- mounted
(or on any other flat surface) without any fixing, remaining steady no matter what the angle of
the head is. Fully operational in any mounting position, hanging upside-down, side mounted, or
set on a flat level surface, etc. When clamp mounting; always use and install the supplied safety
cable as an added safety measure to prevent any accidental damage in the event of the clamp
failure. Make sure that this fixture is kept at least at 0.1m away from any flammable material,
such as decoration, etc.

DMX-512 control connection

Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other
side to the male 3-pin XLR input of the moving head. You can chain the multiple moving head
together through a serial linking. The needed cable should be a two core, screened cable with
XLR input and output connectors. Please refer to the diagram below.