SGM PALCO 3+ User Manual page 5

having pressed the button and exit to the status of Address Display. Press BLACK OUT+ 0 to
reset to the initial status of infrared setting.(except address).
PROG
AUTO RUN：Press this button to enter the built- in program.
SOUND ACTIVE： Press this button to enter the sound active (it depends on whether this
function exists in the lighting fixture).
MODE： Every lighting fixture which receives the infrared signal changes it's addresses at
the same time if not pressing this button when setting the address. Choose what fixture is to be
changed first, then press this button to change the address. Press it again to the start condition.
For example: there are three lighting fixtures, whose addresses are A001, A003 and A007. If the
three fixtures receive the infrared signal, the address will be changed if the MODE button is not
pressed. If you want to change the address manually, you have to press the MODE button, then
choose one of the fixture that is to be changed (A003, etc.) press SA button to change the address
(A010 etc.). This fixture address will be changed to A010.
ALON/MAST： Press this button to the master-slave mode.
SET ADDR： Press this button + NUMBER+ ENTER to set the address.
ENTER： press this button to confirm.
0 9
Under different function, press the numbers and ENTER to change the address or the dimming.
R
press this button for the red color full brightness, Press number+ ENTER to dim the red
R
color, press again, the red color will die out.
G
press this button to the green color full brightness, press number+ ENTER to dim the green
G
color, press again, the green color will die out.
B
press this button to the blue color full brightness, press number+ ENTER to dim the blue
B
color, press again, the blue color will die out.
：press this button to the white color full brightness, press number+ ENTER to dim the