Connecting To A Dmx Control Device; Enabling The Wireless Cone Antenna Receiver - SGM P-5 User Manual

Connecting to a DMX control device

The device is controllable using a DMX control device and it can be connected using either a DMX cable or via the P-5's built-
in wireless receiver system.
If using a cabled DMX system, connect the DMX in cable (with male 5-pin XLR plug) and out cable (with female
plug) to the DMX data link. Terminate the DMX out cable of the last device in the data link. For outdoor installations, use only
IP-rated XLR connectors suitable for outdoor use.

Enabling the wireless cone antenna receiver

Before you enable the wireless cone antenna, ensure that there is no DMX cable
connected to the device.
Use the "Settings→Wireless DMX→Enable" menu to enable wireless DMX and
the "Settings→Wireless DMX→Wireless LED Status" to confirm that a data con-
nection has been established. The wireless cone antenna operates at a frequency
of 2.4 GHz, so ensure that the DMX transmitter is configured to operate in this
range.
20
5-pin XLR