Table of Contents
Advertisement
sends "Auto Program Part 1" to the Slave unit. If set to "Slave 2", the Slave unit receives "Auto
Program Part 2".
To start a Auto Program please proceed as follows:
1. Slave-Setting
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Set to slave" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter button to confirm.
• Press the Mode/ Esc button in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Auto Program" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Master" or "Alone". The selection "Alone" means Stand Alone-
mode and "Master" that the device is defined as master.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Select programs" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and thus
select which Slave program is to be sent. Selection "Part 1" means, that the Slave unit runs the
same program as the master units.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
4. Program selection for Edit Program
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select the desired program. With this function you can edit specific scenes
into a specific program.
• Press the Enter button to confirm.
• Press the Mode/ Esc button in order to return to the main menu.
5. Automatic Scene Recording
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Edit scenes" by turning the encoder.
• Turn the encoder to select the desired scene numbers. You can program a maximum number of
250 scenes.
Advertisement
Table of Contents
