SGM PALCO 3+ User Manual page 13

Software version
With this function, you can display the device software version.
• Select "Software version" by turning the encoder.
• Press the encoder, the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-
1.0", "V-2.6".
• Turn the encoder to read the version of every individual IC.
• Press the Mode/Esc- button in order to return to the main menu.
PERSONALITY
Status Settings
Address via DMX
With this function, you can adjust the desired DMX- address via external controller.
• Select "Address via DMX" by turning the encoder.
• Press the encoder, the display shows "ON" or "OFF".
• Turn the encoder to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press the encoder to confirm.
• Press the Mode/Esc- button in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX- value of channel 2 to "7"or "8". When set to "7" you can adjust the starting
address between 1 and 255. When set to "8" you can adjust the starting address between 256
and 511.
• Set the DMX- value of channel 3 to the desired starting address. If you want to set the starting
address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set
the starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3 to "164"
(256+ 164= 420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting
address is set.
No DMX Status
With this function, when the drive is not DMX signal, it runs automatism, close, hold and
music, the default is hold.
Display Setting
Shut off time
With this function you can shut off the LCD display after 2 to 59 minutes. Turn the encoder in
order to select the desired shut off time.
Locked keys the display
With this function you can activate the automatic key-lock function. If this function is activated,
the keys will be automatically locked after exiting the edit mode for 15 seconds. Keep the
[Mode/ Esc] key pressed for 3seconds if you want to deactivate the key- lock status.
1. Tap the [UP] button until "KEY LOCK" is displayed then tap the [ENTER] button.
2. Press the [UP] button to select "ON" to activate this function, or "OFF" to deactivate this
function. Press [ENTER] to confirm.
3. Press [Mode/ Esc] to return to the main menu.
Temperature C/F
With this function, display the temperature in Celsius or Fahrenheit.