Table of Contents
Advertisement
The applicable temperature for the lighting is between-25°C～45°C. Do not use the lighting
under or above the temperature.
The installation of the effect has to be built and constructed in order to hold 10 times its weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.
The operator has to make sure that the safety relating and machine technical installations have
been approved by an expert before operating the device the first time.
These installations have to be approved by a skilled technician once a year.
Cautions:
The effect should be installed outside areas where people may reach it, walking by or being
seated next to it.
Overhead mounting requires an extensive experience, including amongst others calculating
working load limits, installation material used and periodic safety inspection of the whole
installation material and device. If you lack these qualifications, do not attempt the installation
yourself. Improper installation can result in bodily injury.
Before mounting make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
Connect the fixture to the mains with the power plug.
Clamp installation method
Please refer to the picture below:
Advertisement
Table of Contents
