Table of Contents
Advertisement
Macintosh Clients
From your Macintosh, you can access the Internet via XRT. The procedure is as follows.
1.
Open the TCP/IP Control Panel.
2.
Select Ethernet from the Connect via pop-up menu.
3.
Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field
can be left blank.
4.
Close the TCP/IP panel, saving your settings.
ë Note
Linux Clients
To access the Internet via XRT, it is only necessary to set XRT as the "Gateway".
Ensure you are logged in as "root" before attempting any changes.
Fixed IP Address
By default, most Unix installations use a fixed IP Address. If you wish to continue using a
fixed IP Address, make the following changes to your configuration.
•
Set your "Default Gateway" to the IP Address of XRT.
•
Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows shell.
1.
Start your X Windows client.
2.
Select Control Panel - Network
3.
Select the "Interface" entry for your Network card. Normally, this will be called "eth0".
4.
Click the Edit button, set the "protocol" to "DHCP", and save this data.
5.
To apply your changes
• Use the "Deactivate" and "Activate" buttons, if available.
• OR, restart your system.
If using manually assigned IP addresses
instead of DHCP, the required changes are:
• Set the Router Address field to XRT's IP
Address.
• Ensure your DNS settings are correct.
Preparations & Installation
21
Advertisement
Table of Contents
