Table of Contents
Advertisement
•
If your router's default IP Address (192.168.0.1) is already used by another device, the
other device must be turned OFF until router is allocated a new IP Address during
configuration.
Using UPnP (XRT-401C)
If your Windows system supports UPnP, after proper UPnP service configuration. When you
connect your computer with XRT-401C, an icon for XRT-401C will appear in the system tray,
notifying you that a new network device has been found, and offering configurations in My
Network Places to the newly-discovered device.
•
Unless you intend to change the IP Address of XRT-401C, you can accept the desktop
shortcut.
•
Whether you accept the desktop shortcut or not, you can always find UPnP devices in My
Network Places (previously called Network Neighborhood).
•
Double - click the icon for XRT-401C to start the configuration. Refer to the following
section for details of the initial Internet connection configuration process.
Using your Web Browser
To establish a connection from your PC to XRT:
1.
After installing XRT in your LAN, start your PC. If your PC is already running, restart it.
2.
Start your WEB browser.
3.
In the Address box, enter "HTTP://" and the IP Address of XRT, as in this example, which
uses XRT's default IP Address:
HTTP://192.168.0.1
If you can't connect
If your router does not respond, check the following:
•
XRT is properly installed, LAN connection is OK, and it is powered ON. You
can test the connection by using the "Ping" command:
•
Open the MS-DOS window or command prompt window.
•
Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or your
PC's IP address is not compatible with XRT's IP Address. (See next item.)
•
If your PC is using a fixed IP Address, its IP Address must be within the range
192.168.0.2 to 192.168.0.254 to be compatible with XRT-401C's default IP
Address of 192.168.0.1. Also, the Network Mask must be set to 255.255.255.0.
See Chapter 4 - PC Configuration for details on checking your PC's TCP/IP
settings.
•
Ensure that your PC and XRT are on the same network segment. (If you don't
have a router, this must be the case.)
4.
You will be prompted for a username and password, as shown below.
Machine Configurations
23
Advertisement
Table of Contents
