Planet XRT-401C User Manual page 44

XRT C Series User Manual
PPTP (Point-to-Point Tunneling Protocol) configuration
Select PPTP if your ISP requires the PPTP protocol to connect you to the Internet.
Your ISP should provide all the information required in this section. (Please refer to
"PPTP" section for more detail information.)
Static IP Address configuration
Select Static IP address if your ISP has given you a specific IP address for you to use.
Your ISP should provide all the information required in this section. (Please refer to
"Fixed IP" section for more detail information)
WAN Policy Configuration (XRT-402C/XRT-204C)
When multiple WAN connections are connected with XRT-402C/XRT-204C, you may
configure WAN policy for multi-homing feature in XRT-402C/XRT-204C. Each WAN policy
"Enable (Activated on
can be configured separately. When all WAN interfaces are set as
start)", XRT will balance the load between all active WAN connections according to the
Send/Receive rate of the WAN ports. You can setup an IP for the router to detect if the WAN
line is connected. If the router fails to ping the IP, it would recognize the WAN line as not
connected, and will stop directing the Internet traffic to this WAN port. The LAN-to-WAN
traffic will be redirected to the other active WAN port. The Intranet users will not become
aware of this change and keep surfing the Internet smoothly. You also can setup a WAN port
as a backup WAN port. Backup WAN port would not be activated when your router start up.
When the other active WAN port fails to connect to the Internet, the backup WAN port will be
activated and take over all the traffic.
40