Intended Use; Applications; Mig/Mag Standard Welding; Documents Which Also Apply - EWM Pico 350 cel puls Operating Instructions Manual

3

Intended use

Hazards due to improper usage!
The machine has been constructed to the state of the art and any regulations and
standards applicable for use in industry and trade. It may only be used for the welding
procedures indicated at the rating plate. Hazards may arise for persons, animals and
material objects if the equipment is not used correctly. No liability is accepted for any
damages arising from improper usage!
• The equipment must only be used in line with its designated purpose and by trained or
expert personnel!
• Do not improperly modify or convert the equipment!
3.1

Applications

Arc welding system for MMA DC welding and, as secondary process, TIG DC welding with lift arc (touch
starting) or MIG/MAG welding with constant voltage (CV) or constant current (CC).
3.1.1

MIG/MAG standard welding

A suitable wire feed unit (system component) is required in order to operate the welding machine!
Pico 350, -400
3.2

Documents which also apply

3.2.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information regarding
warranty, maintenance and testing at www.ewm-group.com!
3.2.2

Declaration of Conformity

This product corresponds in its design and construction to the EU directives listed in the decla-
ration. The product comes with a relevant declaration of conformity in the original.
3.2.3

Welding in environments with increased electrical hazards

In compliance with IEC / DIN EN 60974, VDE 0544 the machines can be used in environ-
ments with an increased electrical hazard.
3.2.4

Service documents (spare parts and circuit diagrams)

Do not carry out any unauthorised repairs or modifications!
To avoid injury and equipment damage, the unit must only be repaired or modified by
specialist, skilled persons!
The warranty becomes null and void in the event of unauthorised interference.
• Appoint only skilled persons for repair work (trained service personnel)!
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.2.5

Calibration/Validation

We hereby confirm that this product was tested with calibrated measuring equipment according to the ap-
plicable standards IEC/EN 60974, ISO/EN 17662 and complies with the permissible tolerances. Recom-
mended calibration interval: 12 months.
099-002060-EW501
30.04.2020
WARNING
Pico drive 4L

WARNING
Intended use
Applications
Pico drive 200C
13