Bottom Panel Connections - Watchguard AP225W Hardware Manual

Bottom Panel Connections

DC IN
If PoE power is unavailable, you can power the device with the optional 12V DC 2.5A power adapter
(WG9009).
Pass-Through
The pass-through port is a wired port that enables you to extend the wired network after the AP is
mounted on the wall. You can plug another device into the pass-through port on the bottom panel of
the AP. The pass-through ports on the rear panel and bottom panel of the AP are internally
connected. The traffic on the pass-through port does not interfere with AP traffic, and no policies can
be applied to pass-through port traffic.
LAN3/PoE Out
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps. You can use this interface
as a wired extension of an SSID or a VLAN extension. This port can also provide PoE (802.3af)
power for another device. The AP must be connected to PoE+ (802.3at) or DC power to enable
power on the LAN3/PoE Out port. Link aggregation on this interface is not supported.
The PoE Out port is intended to power small devices such as IP-based phones,
cameras, or other similar devices. WatchGuard recommends that you do not power
another access point from this port.
LAN2
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps. You can use this interface
as a wired extension of an SSID or a VLAN extension. Link aggregation is not supported on this
interface.
WatchGuard Technologies, Inc.
WatchGuard AP225W Hardware Guide
5