Watchguard AP225W Hardware Manual page 14

WatchGuard AP225W Hardware Guide
To power the AP with the optional 12V DC power adapter and connect the AP to your network:
Plug the optional 12V power adapter into the DC IN power port on the bottom panel of the AP225W,
n
then plug the power adapter into an AC power source.
To connect the AP225W to the network, connect an Ethernet cable into the POE In LAN/Uplink port
n
on the rear panel of the AP. Make sure the other end of the Ethernet cable is connected to your network
through a hub or switch.
Connect an optional Ethernet cable from your network into the PASS-THROUGH port on the rear
n
panel of the AP225W.
10 WatchGuard Technologies, Inc.