Hardware Description; Bottom Panel Connections - Watchguard AP432 Hardware Manual

WatchGuard AP432 Hardware Guide

Hardware Description

The access point has these connections on the bottom panel of the device.

Bottom Panel Connections

Reset Button
Resets the access point to factory-default settings.
Use a paper clip or other small object to press the reset button through the hole.
n
Press and hold the reset button for up to 10 seconds. When you release the reset button, all
n
LEDs will go off to indicate that the device has rebooted.
2.5 G / LAN (PoE+)
This is a 2.5 Gbps Ethernet LAN port that connects the access point to a wired LAN connection
through a switch or hub. This port also provides PoE+ (802.3at) power for the device.
DC 12V
If PoE power is unavailable, you can power the device with the optional 12V DC power adapter
(WG9009).
9 WatchGuard Technologies, Inc.