Hardware Description; Bottom Panel Connections - Watchguard AP430CR Hardware Manual

WatchGuard AP430CR Hardware Guide

Hardware Description

Bottom Panel Connections

2.4/5GHz
Antenna connectors for the dual band Wi-Fi radios.
2.4/5GHz Scan
Antenna connector for the dual band security scanning radio.
LAN 1 (POE+)
The LAN 1 port is a 5 GbE port that connects the access point to a wired LAN connection through a
switch or hub. This port also provides PoE+ (802.3at) power for the access point.
LAN 2
The LAN 2 port is a 1 GbE LAN port that you can use as a wired extension for an SSID or for link
aggregation.
Reset Button
The reset button is located above the LAN 2 port. You must remove the weatherproof connector to
access the LAN 2 port and the reset button.
To reset the access point to factory-default settings:
Remove the weatherproof connector from the LAN 2 port.
n
Use a paper clip or other small object to press the reset button above the LAN 2 port.
n
Press and hold the reset button for up to 10 seconds. When you release the reset button, all LEDs
n
will go off to indicate that the access point has rebooted.
9 WatchGuard Technologies, Inc.