Watchguard AP225W Hardware Manual page 11

This table provides detailed information about the device indicators:
LED
Power
Uplink (PoE In)
LAN1/2/3
(LAN interface status
is indicated by a
single LED for all
interfaces)
2.4 GHz and
5 GHz radios
Third Radio (WIPS)
WatchGuard Technologies, Inc.
Status Description
Off Powered off
Solid Powered on
Green
Flashing AP cannot connect to Wi-Fi Cloud or the Gateway Wireless
Green Controller
Flashing AP did not receive an IP address from the DHCP server
Amber
Off No Ethernet link
Network interface is up and connected at 10/100/1000 Mbps.
Solid
Green
Off No Ethernet link
8.8.2 and higher: For APs with additional LAN ports, interface will
Solid
be green if the interface is up and a VLAN extension, wired
Green
extension, or link aggregation is enabled on the interface in Wi-Fi
(Wi-Fi
Cloud.
Cloud
mode) 8.8.1: Network interface is up and connected at 10/100/1000
Mbps.
Network interface is up and connected at 10/100/1000 Mbps.
Solid
Green
(Local
mode)
8.8.2 and higher: No SSID enabled on the radio.
Off
8.8.1: Wireless radio is inactive.
8.8.2 and higher: SSID enabled on radio.
Solid
Green
8.8.1: Wireless radio is active.
Off Wireless radio is inactive
Solid WIPS scanning is active (Wi-Fi Cloud mode only)
Green
WatchGuard AP225W Hardware Guide
7