Connect The Ap - Watchguard AP225W Hardware Manual

Connect the AP

Connect the Ethernet cables to the appropriate ports on the rear panel of the AP.
To power the AP with a PoE power source and connect the AP to your network:
Plug one end of the Ethernet cable from your network into the POE In LAN/Uplink port on the rear
n
panel of the AP225W. Make sure the other end of the Ethernet cable is connected to your network
through a hub, switch, or injector with PoE power enabled.
Connect an optional Ethernet cable from your network into the PASS-THROUGH port on the rear
n
panel of the AP225W.
WatchGuard Technologies, Inc.
WatchGuard AP225W Hardware Guide
9