Hardware Description; Bottom Panel Connections - Watchguard AP330 Hardware Manual

WatchGuard AP330 Hardware Guide

Hardware Description

The AP has these connections on the bottom panel of the AP.

Bottom Panel Connections

Reset Button
Resets the AP to factory-default settings.
Use a paper clip or other small object to press the reset button through the hole.
n
Press and hold the reset button for up to 10 seconds. When you release the reset button, all LEDs
n
will go off to indicate that the AP has rebooted.
USB Port
This port is currently not in use.
Serial Console
RJ-45 port is for serial console connections to the access point.
LAN (POE+)
This is an LAN port that connects the AP to a wired LAN connection through a switch or hub. This
port also provides PoE+ (802.3at) power for the AP.
4 WatchGuard Technologies, Inc.