Hardware Description; Device Connections And Buttons - Watchguard AP322 Hardware Manual

Hardware Description

Device Connections and Buttons

Ethernet Network Interfaces
LAN1: Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps and PoE+
connectivity. The WatchGuard AP322 can be powered by an 802.3at PoE+ connection on the LAN1
interface.
LAN2: Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps. This interface can be
used as a wired extension for a wireless SSID that has NAT enabled. For more information on how to
configure NAT settings for an SSID, see the WatchGuard Wi-Fi Cloud Help. 
The LAN2 port cannot be used for link aggregation.
For APs managed locally by a Gateway Wireless Controller with Fireware v12.2.1 and higher, you can
bridge together the LAN ports on AP models that have two LAN interfaces. This enables you to extend
the wired network on the second LAN interface. For more information, see the Fireware Help.
Reset Button
Resets the WatchGuard AP to factory-default settings. You must use a paper clip or other small object
to press the reset button through the hole.
To reset the device to factory-default settings, power cycle the device (remove the power cable and
reconnect it again). While you reconnect the power source, press and hold the reset button for at
least 60 seconds until the power, LAN1, and 2.4 GHz indicators are green.
Hardware Guide
Hardware Specifications
3