WatchGuard AP225W Hardware Guide
LAN1
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps. You can use this interface
as a wired extension of an SSID or a VLAN extension. Link aggregation is not supported on this
interface.
Reset Button
Resets the AP to factory-default settings.
Use a paper clip or other small object to press the reset button through the hole.
n
Press and hold the reset button for up to 10 seconds until all LEDs go off to indicate that the AP
n
has rebooted.
Device Indicators
The AP225W has these LED indicators:
6
WatchGuard Technologies, Inc.