How To Clean The Uv-Led Devices - Roland VersaUV LEF2-300 Regular Maintenance Manual

How to Clean the UV-LED Devices

I M P O R TA N T
Important notes on this procedure
• Before performing this operation, remove any objects to be printed on.
• To prevent the print heads from drying out, finish this procedure in 10 minutes or less. A warning
beep sounds after 10 minutes.
• The cloths, alcohol, and similar items used in cleaning are not included with the product.
When a warning beep sounds during cleaning
• A warning beep sounds 10 minutes after operation starts. Stop work, close all the covers, and then
press [ENTER]. After that, restart the procedure from the beginning.
Anhydrous ethanol or
isopropyl alcohol
CAUTION
CAUTION
CAUTION
CAUTION
Procedure
Remove the object to be printed on.
A
Move the print-head carriage.
B
1 Press [MENU].
2 Press [ ] several times to display the screen shown below.
MENU
SUB MENU
Cleaning That Must Be Performed Once a Month or More
Required items (commercially available items)
Cloth (that is not fluffy)
Do not perform cleaning immediately after printing has finished. (Wait
approximately 15 minutes after printing finishes.)
The area around the UV-LED device is hot and may cause burns.
When using anhydrous ethanol or isopropyl alcohol, be sure to follow the
product's usage precautions.
Exercise caution regarding items such as fire, ventilation, and rashes.
Only use anhydrous ethanol or isopropyl alcohol.
Using chemicals (or similar substances) other than anhydrous ethanol or
isopropyl alcohol may lead to UV-LED device damage.
Use cloth that is not fluffy to wipe off the parts. Do not use a hard
material such as metal.
Using cloth that is fluffy or a hard material such as metal may lead to UV-
LED device damage.
Rubber gloves
2.Regular Maintenance
57