Roland VersaUV LEF2-300 Regular Maintenance Manual page 42

Maintenance That Must Be Performed Daily
M E M O
If the possibility of the print heads hitting the head refresher (or some other obstacle) is
detected, head refreshing is canceled and the following message is displayed.
CHECK HEIGHT OF
HEAD REFRESHER
Press [ENTER] to clear the message.
Possible causes and their countermeasures are shown below. Check the situation, and then
perform head refreshing again.
• An obstacle or a jig may be in the way. Correctly reattach the head refresher by removing the
obstacle or reviewing how the jig is attached.
• The height of the head refresher may have been changed from the standard height due to the
influence of the jig. In this situation, set the installation height of the head refresher.
" User's Manual: "Setting the Installation Height of the Head Refresher"
(https://webmanual.rolanddg.com/LEF2-300)
When the following screen is displayed, open the front cover.
P
REMOVE HEAD
REFRESHER
Open the sheet retaining cover and remove the head cleaning sheet.
Q
Remove the sheet by pinching parts that are clean of ink and cleaning liquid. Use tweezers or
gloves if getting cleaning liquid on your hands seems unavoidable.
Check that there are traces of ink being wiped off onto the head cleaning sheet.
R
I M P O R TA N T
Quickly dispose of used head cleaning sheets.
Leaving a used head cleaning sheet inside the machine may lead to the machine's painting peeling off.
To purchase head cleaning sheets, contact your authorized Roland DG Corporation dealer or visit our
website (http://www.rolanddg.com/).
2.Regular Maintenance
40