Roland VersaUV LEF2-300 Regular Maintenance Manual page 41

When the following screen is displayed, apply head refreshing cleaning liquid to the
M
head cleaning sheet.
APPLY CL-LIQUID
START REFRESH
P o i n t
• As a guideline, apply two drops (A) or three drops (B) of cleaning liquid to a single cleaning pad.
Apply cleaning liquid as shown in the following figure, using the holes in the sheet retaining cover
(a total of 16 holes) as guidelines for the positions where to apply the liquid.
• Soak the cleaning liquid into the entirety of the head cleaning sheet covering the wiping part.
Rubbing the print heads with a dry sheet may lead to malfunctions.
A
I M P O R TA N T
Do not leave the bottle of cleaning liquid for head refreshing on the flat table.
Leaving the cleaning liquid bottle on the flat table and proceeding to the next operation will lead to
an error caused by the bottle hitting the head gap sensor.
Close the front cover.
N
Press [ENTER].
O
APPLY CL-LIQUID
START REFRESH
The screen shown below appears, and the head refresh starts. The (approximate) remaining
time for the procedure is displayed on the screen. (The display shown below is an example.
"01:45" = "1 minute and 45 seconds")
CLEANING...
>> 01:45
B A
Maintenance That Must Be Performed Daily
B
B
2.Regular Maintenance
39