How To Clean The Uv-Led Device - Roland VersaUV LEC2-300 Regular Maintenance Manual

Cleaning That Must Be Performed Once a Month or More
How to Clean the UV-LED Device
IMPORTANT
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the print heads from drying out, finish this procedure in 10 minutes or less. A warning beep sounds
after 10 minutes.
• The cloths, alcohol, and similar items used in cleaning are not included with the product.
When a warning beep sounds during cleaning
• A warning beep sounds 10 minutes after operation begins. Stop work, close all the covers, and then press
[ENTER] to end the manual cleaning mode. After that, restart the procedure from the beginning.
Anhydrous ethanol or isopropyl
CAUTION
CAUTION
CAUTION
CAUTION
Procedure
A
Remove any media.
B
Remove the media clamps.
C
Press [FUNCTION].
34
Required items (commercially available items)
alcohol
Do not perform cleaning immediately after printing has finished. (Wait
approximately 15 minutes after printing finishes.)
The area around the UV-LED device is hot and may cause burns.
When using anhydrous ethanol or isopropyl alcohol, be sure to follow the
product's usage precautions.
Exercise caution regarding items such as fire, ventilation, and rashes.
Only use anhydrous ethanol or isopropyl alcohol.
Using chemicals (or similar substances) other than anhydrous ethanol or isopropyl
alcohol may lead to UV-LED device damage.
Use cloth that is not fluffy to wipe off the parts. Do not use a hard material such
as metal.
Using cloth that is fluffy or a hard material such as metal may lead to UV-LED
device damage.
2.Regular Maintenance
Cloth (that is not fluffy) Rubber gloves