Roland VersaUV LEF2-300 Regular Maintenance Manual page 33

5.
Set the print area.
Procedure
Press [ ], [ ], [ ], or [ ] when the following screen appears.
A
SCAN: 0.0mm
FEED: 0.0mm
The flat table and the print heads move so that the pointer points at the previously set printing
base position.
Press [ ], [ ], [ ], or [ ] to move the pointer until it points to a position in the right
B
foreground of the print area (the base position).
Press [ENTER].
C
The print heads return to the home position and the following screen is displayed.
WIDTH: XXX.Xmm
LENGTH:XXX.Xmm
M E M O
• The previously set values are displayed for "WIDTH" and "LENGTH."
• When the object to be printed on comes into contact with the head gap sensor, the screen shown
below appears and the setup is canceled. Redo from
detected automatically."
CHECK TABLE
HEIGHT
Press [ ], [ ], [ ], or [ ] to set the "WIDTH" to 110 mm (4.3 in.) or more and the
D
"LENGTH" to 70 mm (2.8 in.) or more.
The pointer moves until it points to a position in the inner left of the print area.
.
Maintenance That Must Be Performed Daily
P. 30 "4. The height of the object to be printed on is
2.Regular Maintenance
31