10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
Wall-mount model GS110TUP
The bottom panel of the switch provides two VESA mount holes that allow you to mount
the switch to a wall. The switch comes with wall-mount screws and anchors that you can
secure to a wall and attach the switch to.
The distance between the VESA holes is 3.94 in. (100 mm). The following figure shows
the bottom panel of the switch.
Figure 10. VESA hotels at the bottom panel of model GS110TUP
Wall-mount model GS110TUP horizontally
horizontally to a wall, either with the back panel facing down (the cables will be at the
bottom) or facing up (the cables will be at the top).
To mount model GS110TUP horizontally to a wall:
1. Locate the two holes on the bottom panel of the switch.
2. Mark the two mounting holes on the wall where you want to mount the switch.
The two mounting holes must be at a precise horizontal distance of 3.94 in. (100 mm)
from each other.
3. Drill holes into the wall for two anchors in which you will insert M4 x L25 mm screws.
The screws and anchors are in the switch package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about 6 mm (¼ inch) of each screw protruding from the wall so that you can
insert the screws into the holes on the bottom of the switch.
5. Line up the holes on the bottom panel of the switch with the screws in the wall and
mount the switch to the wall.
Installation
You can mount model GS110TUP
34
Hardware Installation Guide