Step 9: Manage The Switch - NETGEAR GS110TUP Hardware Installation Manual

10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
GS710TUP). Make sure that the AC outlet is not controlled by a wall switch, which can
turn off power to the switch.
To apply power:
1. Connect the plug of the power cable to the power receptacle on the back of the
switch.
2. Plug the DC power adapter (model GS110TUP) or AC power cable (model GS710TUP)
into a power source such as a wall socket or power strip.
3. Check to see that the LEDs on the switch light correctly.
When you apply power, the Power LED on the switch front panel lights and the port
LEDs for attached devices light.
Note: After you apply power, the Power LED lights solid amber while the switch
starts. After about one minute, the switch completes its startup process and the
Power LED turns from amber to solid dark green.
If the Power LED does not light, check to see that the power cable is plugged in
correctly and that the power source is good.

Step 9: Manage the switch

The switch is a plug-and-play device that starts switching as soon as you plug it into
power and your network.
After you complete the initial log-in procedure, you can configure the switch using the
local browser UI. After you complete the initial log-in procedure, you can also change
the management mode so that you configure the switch using the Insight app, or if you
are an Insight Premium or Insight Pro subscriber, the Insight Cloud portal. For more
information, see Management options on page 8.
For more information about managing the switch using the local browser UI, including
information about tools to discover the switch IP address in your network, see the user
manual, which you can download from netgear.com/support/download/.
For more information about NETGEAR Insight, visit netgear.com/insight and see the
NETGEAR knowledge base articles at netgear.com/support.
For very basic setup and management, you can use the Smart Control Center (SCC)
utility (which requires a Windows-based computer). For information about the SCC
utility, see netgear.com/support/product/SCC.
Note: By default, the DHCP client of the switch is enabled. If the switch cannot get an
IP address from a DHCP server, the switch's default IP address is 192.168.0.239 and the
default subnet mask is 255.255.255.0.
Installation 39 Hardware Installation Guide