Mount Model Gs110Tup To A Pole Or Another Surface - NETGEAR GS110TUP Hardware Installation Manual

10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
The screws and anchors are in the switch package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about 6 mm (¼ inch) of each screw protruding from the wall so that you can
insert the screws into the holes on the bottom of the switch.
5. Line up the holes on the bottom panel of the switch with the screws in the wall and
mount the switch to the wall.
You can mount the switch with the back panel facing left (the cables will be on the
left, see the figure on the left) or facing right (the cables will be on the right, see the
figure on the right). Both figures show the top panel of the switch, with the VESA
holes at the bottom shown transparently.

Mount model GS110TUP to a pole or another surface

You can use an off-the-shelf 100 mm VESA standard mount to secure the switch to a
pole or another surface. The bottom panel of the switch provides two mount holes that
are VESA-compliant.
Installation 36 Hardware Installation Guide