Step 4: Install The Switch; Wall-Mount The Switch - NETGEAR GS418TPP Hardware Installation Manual

Easy-Mount 16-Port Gigabit High Power PoE+ Smart Managed Pro Switch with 2 SFP Ports (240W)
4. Verify that the package contains the following items:
• Switch of the correct model
• Power cord
• Wall-mounting kit
• Rack-mounting kit
• Power cord locker
• Rubber belts
• Rubber footpads for tabletop installation
• Installation guide
5. If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.

Step 4: Install the Switch

You can install the switch on a flat surface, attach it to a wall, attach it to a rectangular
pole or table leg, or mount it in a standard 19 inch (48.26 centimeter) network equipment
rack.

Wall-Mount the Switch

The switch ships with a mount to which you can click-attach the back or bottom of the
switch.
To install the switch to a wall:
1. Place the mount on the wall where you want to mount the switch.
2. Mark the wall where the two mounting holes are.
3. Attach the mount to the wall using the M3.5x16-TP screws provided in the package.
4. Tighten the screws with a No. 2 Phillips screwdriver to secure the mount.
5. Line up the back or bottom of the switch with the mount.
6. Insert the mount's locking tab and hook into the notches on the back or bottom of
the switch.
7. Slide the switch into the mount.
Installation
Model GS418TPP
20 Hardware Installation Guide