Advertisement
Power Up a Chassis with Modular Configuration Power
The figure shows the front (PLIM) side of the LCC with a modular configuration power system installed.
Figure 42: LCC Front (PLIM) Side Slot Numbers
Power Up a Chassis with Modular Configuration Power
This section describes how to power up a chassis with modular configuration AC or DC power shelves installed.
Prerequisites
Before performing this task, you must install and wire the power shelves, install the PMs and alarm modules,
and install the route processor (RP) card. See
Modular Configuration Power
RP, PRP, or DRP Card
or at the power plant should be complete.
Steps
To power on the chassis, perform the following steps:
Installing and Removing Power Components
78
Installing a Modular Configuration Power
Module,
Installing a Modular Configuration Alarm
. If you have a modular configuration DC power system installed, wiring at the BDFB
Installing and Removing Power Components
Shelf,
Installing a
Module, and
Installing an
Advertisement
