Advertisement
Installing and Removing Power Components
Figure 22: Loosening Bolts on Rear of Chassis
Step 2
Install the mounting blocks on the left and right sides of the chassis. The left side is shown in the next figure. A second
mounting block is located on the right side.
Figure 23: Mounting Block Position in Chassis, One per Side
1
Mounting block with two screw holes
2
Holes in chassis to be aligned with the mounting block
Step 3
Unscrew the ejector handles from the front face of the shelf, one on each side.
Step 4
Holding the power shelf underneath with one hand and steadying it with the other, lift the shelf up and slide it partway
into the power shelf slot on the front (PLIM) side of the chassis.
Installing and Removing Power Components
Steps
47
Advertisement
