Advertisement
Installing and Removing Power Components
9. If the chassis is being replaced, use the 10-mm socket wrench to remove the ground cable from the
grounding point on top of the chassis rear (MSC) side panel.
DETAILED STEPS
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the
rear (MSC) side of the chassis or a bare metal surface on the chassis.
Step 2
Using a 10 mm socket wrench, loosen the two M6 hex nuts that attach the grounding L-bracket to the power shelf. Do
not fully remove.
Figure 31: Grounding Brackets
1
Chassis ground cable
2
Two M6 hex bolts attaching ground lug to chassis
5
Two M6 hex nuts attaching grounding L-bracket to shelf
grounding bracket (Step 4)
6
Grounding L-bracket (Step 5)
Installing and Removing Power Components
Steps
57
Advertisement
