Advertisement
Installing and Removing Power Components
Figure 33: DC Terminal Block Cover
Caution
Install the terminal block cover after the input wiring is installed, but before power has been energized.
Required Tools and Equipment
You need the following tools to perform this task:
• ESD-preventive wrist strap
• 6-in. long Number 1 Phillips screwdriver
Steps
To install the DC terminal block covers, go to the rear (MSC) side of the chassis and perform the following
steps:
SUMMARY STEPS
1. Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
2. Align the DC terminal block cover with the cover latch tab.
3. Use the screwdriver to secure the screw into the mounting standoff.
Required Tools and Equipment
Installing and Removing Power Components
61
Advertisement
