Installing and Removing Power Components
Figure 38: Modular Configuration Alarm Module
1
Side of alarm module to be installed on the right side of the opening.
Prerequisites
Before performing this task, you must first remove the upper grille on the front (PLIM) side of the chassis, if
installed.
Caution
Do not attempt to install the alarm module until the modular configuration power shelf is in place and screwed
into the chassis.
Required Tools and Equipment
• ESD-preventive wrist strap
• 6-in. long number 1 Phillips screwdriver
• Modular configuration alarm module (Cisco product number CRS-16-ALARM-C=)
Steps
To install the alarm module, perform the following steps:
SUMMARY STEPS
1. Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Installing and Removing Power Components
Prerequisites
69