Setup Of This Instrument - Olympus OEP-4 Instructions Manual

3.2 Setup of this
Instrument
This section explains items to be confirmed and other
setup items required to use instruments other than the
devices described in "INSTRUCTIONS (BASIC)."
For detailed information on other setup items, see
"Chapter 5 System Setup" on page 37.
Cursor keys
" v " " V " " b " " B "
LCD panel LOAD USER button
MENU button
Figure 3.1
1
Press the MENU button.
2
Set up and confirm n the following procedures.
Table 3.2
Connected Procedure
Instrument
CV-140 You can use these devices at the
CV-240 factory settings.
EU-M60
OTV-SI 1 Press the "B" key until the LCD
panel shows "BASIC SETUP."
2 Press the "V" key until the LCD
panel shows "INPUT SEL."
3 Press the "B" key until "SVIDEO"
are displayed below "INPUT SEL."
OTV-SP1C 1 Press the "B" key until the LCD
OTV-SP1C-G panel shows "BASIC SETUP."
OTV-SX2C 2 Press the "V" key until the LCD
panel shows "INPUT SEL."
3 Press the "B" key until "SVIDEO"
are displayed below "INPUT SEL."
VIDEO: Inputs the signal in
composite signal formats.
S-VIDEO: Inputs the signal in the
Y/C signal format.
COMPONENT: Inputs the signal
in the component signal format.
Table 3.2
Connected Procedure
Instrument
1 Press the "B" key until the LCD
EU-C60
panel shows "BASIC SETUP."
2 Press the "V" key until the LCD
panel shows "INPUT SEL."
3 Press the "B" key until uppercase
letters "VIDEO" are displayed
below "INPUT SEL."
3
Press the MENU button.
The LCD panel should return to the previous
display.
27

3.2 Setup of this Instrument

3