Chapter 3 Inspection Before Use; Setup Of Connected Equipment - Olympus OEP-4 Instructions Manual

Chapter 3 Inspection Before Use

This document, "INSTRUCTIONS (ADVANCED),"
explains equipment except described in
"INSTRUCTIONS (BASIC)."
Refer to the instruction manuals of the connected
equipment and set them up as required for use with this
instrument.
Certainly, refer to Chapter 3 "Inspection Before Use" for
"INSTRUCTIONS (BASIC)" which has description of
inspections except connected equipment and this
instrument.

3.1 Setup of Connected Equipment

Table 3.1
Connected Instruction Manual
equipment references
CV-140/240 "5.3 User Preset"
"Setting "Scope Switch 1"
Through "Scope Switch 4""
"5.5 Settings for Ancillary
Equipment"
"Printer Setup"
OTV-SI "5.9 Remote control
switches"
OTV-SP1C/ "5.1 Output setup"
SP1C-G "Selection of Interlacing/
Progressive scanning"
"5.1 Output setup"
"Selection of the RGB/
YPbPr image signal"
"5.11. Remote control
switches"
"5.12 Setting a function to
the keyboard"
"Setting the "F4" key"
Setup Item Setup
"Scope switch 1" "Print"
"Scope switch 2" "P.Back"
"Scope switch 3"
"Scope switch 4"
"Type" "OEP2"
"Mode" "1," "2," "4," or "8" Select the number of multi-picture images in
"Qty" "1" – "9"
"Mon." "Auto"
"Manu."
Remote control "RELES"
switch on the
videoscope or
camera head
Interlace "Interlace"
/Progressive
switch
RGB/YPbPr switch "RGB"
Remote control "RELEASE"
switches on the
camera head
"F4" key "RELEASE"
"REL+DIG.CAP."
Note
Select the functions to be controlled from the
scope switches on the videoscope or OES
video converter.
Select any setting, as required.
Select the printer type. Be sure to set "Type"
to "OEP2" when using this instrument.
the printed picture. Select any setting.
This instrument is not compatible with "6"
and "16."
Select the number of prints. Select any
number, as required.
Select whether the image captured in the video
printer is automatically displayed on the
monitor. Select either setting, as required.
Select the function to be controlled from the
remote control switch on the videoscope or
camera head.
Select any setting, as required.
Select the scanning method of the image
output signal.
Be sure to set this item to "Interlace" when
using this instrument.
Select the format of the image output signal.
Be sure to set this item to "RGB" when using
this instrument. When you use this instrument
with this item set to "YPbPr," see "Setting
"SD FORMAT"" on page 49.
Select the function to be controlled from the
remote control switch on the camera head.
Select any setting, as required.
Select the function to be controlled from the
"F4" key of the keyboard.
Select any setting, as required.
"REL+DIG.CAP." is available in OTV-SP1C
only.
3.1 Setup of Connected Equipment
3
25